Harmony HTB3X Shutter Remote (Set of 2)

【Price Reduced Due to Minor Scratches】

Shutter Remote Control HTB3X Harmony [Brand New, Unused] Electric Shutter

Set of 2 remote controls for operating the shutter open/close functions.

- Model: HTB3X
- Functions: Open/Close Operation Buttons (ON, OPEN, CLOSE, STOP)
- Quantity: Set of 2

Operation confirmed
Batteries included

【Remote Control Registration Procedure】
(Easy setup trick included at the end)

Step 1: Start Receiver Setup Mode
Turn the power to the receiver unit near the shutter unit off and on again, or press and hold the receiver's setup switch until you hear a beep.

(Regarding power cycling:
There is a switch or breaker near the shutter motor. Turn this on and off.)

Step 2: Register Remote Control
Within 5 minutes of performing Step 1, press the STOP button on the remote control you wish to add three times.
Press it three times at a rate of once per second.
The receiver will beep pi-pi to indicate that it has received the remote control's signal.
If you wish to register multiple remote controls, repeat this step for each additional remote.

Step 3: Registration Complete
Turn the receiver power off and on again (keep it off for 5 seconds or more), or press and hold the setup switch until you hear a beep.
The receiver will beep rapidly pi-pi! pi-pi!. Calmly press the STOP button three times as you did initially.
The receiver will beep pi-pi, pi-pi to indicate that registration is complete.

*Easy Trick (Safe and anyone can do it)
If you are unsure where the receiver is located or which device it is, making it difficult to turn on and off, turn off the main breaker in your home's electrical panel for 10 seconds, then turn it back on. This effectively allows you to power cycle the receiver.
However, please note that you may need to reset the time settings on other home appliances. This is done at your own risk.